Error 1014? Trying to force UpdateBaseBand, info needed
I did the hardwareunlock. Everything went well, till the very last step: minicom "hung" and had the wrong dir in it /dev/modem/ instead of /dev/tty.baseband. I then changed the setting in minicom, but the phone wouldnt accepte the AT command. I then rebooted. Now its stuck in recovery mode. A restore with iTunes gives me an unknown error 1014.
I can connect with iPhuc, but force UpdateBaseBand gives an error:
i'm doing the following:
1. have the 1.0 firmware on my harddrive in a folder called phonedmg
2. start up iphuc, run: grestore phonedmg
3. exit iphuc, reconnect, to get to restore mode
4. force UpdateBaseBand
It goes on to say the same thing as you get: but my message says: will update with usr/local/standalone/ICE03.12.06_G.fls and usr/local/standalone/ICE03.12.06_G.eep
Preparing to flash using /dev/tty.baseband
So it uses the ICE-files from the "old" firmware. After that it reboots a few times, but then goes on to do the update, or so it seems:
it gives 100 messages: ProgressUpdate runs... showing lines from 01 til 100
but then ends with:
ProcessDetailUpdate: Sending end-pack
ProcessOutlineUpdated: Process time was 2 min 3 sec.
Error: Failed to download .FLS: Could not evrify downloaded image.
I had a v1.02 iPhone before I started the update, so I can imagine it cant verify the image? I'd expect the thing to use the 03.14.08_G update file, instead of the old 03.12.06 one?
Any idea how to get this to work?