I have no sound at all, unless I use speaker phone. The ipod does not have sound either.

I have a phone that was SW unlocked with anysim with firmware 1.0.2 then downgraded (virganized) and upgraded to 1.1 and unlocked

did you restart after performing the unlock?

plug in your headphones all the way and move them around a little in the jack...just try to like push it all the way in HARD, try to move it sideways, then pull it out...everything should work..if not, do it again. This is a hardware issue with the headphone jack not software

no,

you need to flash the BB..


virginize!!!! search for it

Originally Posted by babak

plug in your headphones all the way and move them around a little in the jack...just try to like push it all the way in HARD, try to move it sideways, then pull it out...everything should work..if not, do it again. This is a hardware issue with the headphone jack not software

I have done this few times when iphone sound stops and it works.. its a bug in he headset hardware....

It sounds to me like you stuck in bluetooth mode. Try turning bluetooth off and on a couple of times.

I have same problem too. Tried to restore 1.0.2 and restore BB using terminal. Still not work. I guess this is haerware problem.

This happened to me just 2 hours ago. I plugged in the headset and the problem was gone.
Strange.

I think the problem is that you may have some dust in your earphone jack. Try to clean with some window polish (just a little bit)...

I dont know what you call this little thing, but you use it to clear your ears ( a little stick)

I had this problem recently, the iPhone still thinks the headphones are plugged in.

You need to stick your headphone into the hole a few times.

Took me 10 times, then it finally started working.