I'm assuming the device is either hung or cooked.. anyone encountered this?

(out of curiosity I did a complete disassemble following the ifixit.com guide - including separating the logic and comm boards.. they leave the battery connected in their guide as well)

Ahhhh ... I had this also ... I just took the red battery cable out ... wait for 10 seconds and back again ... later put on the docking and switched back on ....

I hope this will help u ...

hi mate

what tool did you use to open your iphone with???

if it wasn't made of plastic you run the risk of shorting a component as you open it up...

Z

you don't need to remove EVERYTHING!! just the cover

Cool I'll try disconnecting battery..

definitely didn't short anything opening it up (turned it off the last time just before removing the power ribbon/connector)

The same problem.

After som hours, with the geohot software steps, the screen (and Iphone) stops. Doesn´t respond with usb and start button.

Any idea?

Thanks

I just removed the red cable of the baterry for some minutes.

Now, the Logo appears about 10 seconds and dissapears.

How is possible restore the firmware without itunes?

Thanks

Same here, anyone else have this issue?

Battery fully charged?

Have you tried holding the power and middle button to see if it will go to restore mode? I will try it when I get home from work.

edit: Just found this: http://discussions.apple.com/thread....sageID=5192476

GL.

same issue..

Same problem. Mine comes on with apple logo and screen goes white...should of desoldered the red lead when I was soldering....IF anyone gets a fix let me know.