[Iphone 3G 3.0 OS] No Signal After JB

araknis · #1 (**permalink**) 08-14-2009, 09:11 AM

I did a complete restore of 3.0 on my Iphone and then successfully completed the JB process with redsn0w .8. However, I get no signal afterwards (just shows 1 bar). I have tried setting this up as a new phone in Itunes, but same issue.

I had no problems with my 2G Iphone. Any ideas?

gkscit · #2 (**permalink**) 08-14-2009, 01:25 PM

Please apply ultrasn0w andd check

Capt.D · #3 (**permalink**) 08-14-2009, 04:11 PM

Quote:

Originally Posted by araknis

I did a complete restore of 3.0 on my Iphone and then successfully completed the JB process with redsn0w .8. However, I get no signal afterwards (just shows 1 bar). I have tried setting this up as a new phone in Itunes, but same issue.

I had no problems with my 2G Iphone. Any ideas?

Make sure you are using firmware for your device not another one.

araknis · #4 (**permalink**) 08-14-2009, 05:23 PM

thanks for the suggestions. I forgot to mention that I already applied ultrasn0w as well. Also, I am using the correct OS for my 3G device. Any other ideas?

alvink83 · #5 (**permalink**) 08-17-2009, 11:30 PM

Try reset the network settings.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
hardware or software (signal on 2g with newer firmware)	yourwhiteshadow	Quickpwn	1	11-28-2008 04:19 AM
[iPhone 3G] How is your reception after installing firmware 2.1?	vandy1997	3G General Talk	11	09-20-2008 11:45 PM
Poor Signal strength since 2.0.1 (PWNAGE)	Birke	PwnageTool	5	08-19-2008 07:07 PM
[iPhone 3G] Poor Signal Reception	kelkin	3G General Talk	10	07-22-2008 06:06 PM
[iPhone 3G] No Signal > Movistar SIM Card doesn't work ?	gambet	3G General Talk	0	07-12-2008 12:31 PM