 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||
|
|||||||||
|
|
||||||||
|
|||||||||
02-04-2009, 06:52 PM
|
|||
|
|||
stuck with one bar of signal after pwnage...
any ideas on how to sort it.
its a 3g on 2.2.1 pwned with 2.2.5 sorry if this has been covered before, i hve done a search, but did find anything relevant. thanks in advance t just noticed that i have also lost the carrier option under settings/general/network Last edited by Tumble; 02-04-2009 at 07:46 PM.         
|
|
02-06-2009, 05:02 PM
|
|||
|
|||
|
Had the same problem on the 1G, game over - was the coms board...
|
| Sponsored links Remove advertisements | |
|
|
|
|
|
04-19-2009, 12:38 AM
|
|||
|
|||
|
Quote:
 )take the "expert" mode and UNcheck in "General" the {Activate iPhone}, build the ipsw, restore with it. itunes would tell you, it couldn't activate your Phone, so unlock the sim with your PIN and all SHOULD work..., if it does, write it in one other thread, with the same problem. iFrog
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PWNAGE TOOL 2.1 problems? stuck pineapple screen.. | thedips | PwnageTool (3G(S) jailbreak/pwn) | 2 | 09-16-2008 09:03 PM |
| Poor Signal strength since 2.0.1 (PWNAGE) | Birke | PwnageTool | 5 | 08-19-2008 07:07 PM |
| [3G][pwnage 2.0.1][Problem] Jailbreak using pwnage tool but no signal | crackertc | PwnageTool (3G(S) jailbreak/pwn) | 5 | 08-13-2008 08:31 PM |
| [PwnageTool 2.0][3G] - No signal after pwnage | resonance | PwnageTool | 9 | 07-21-2008 08:12 PM |
|
|
Linear Mode
