Ok, so I downloaded this lastnight in hopes to get my D630 working with OSX. Today I burned it to DVD (at a slow speed) and popped it in the drive and booted, I get to the gray screen with the Apple logo, and the spinning image, and it just sits there, doesnt load or anything.

I've booted using the -v command, but it just sits at
IOAPIC: Version 0x20 Vectors 0:23

Doesn't do anything after that.

I've disabled all onboard hardware.

Any suggestions?

Your doing something wrong, check this, did you enable SATA AHCI Support?

__________________
HP Pavilion Elite m9250f
iAtkos v5i (10.5.8), Asus IPIBL-LB MOD BIOS, Intel Quad Core Q6600, 4GB RAM (800mhz), 2x500GB, nVidia 8600GT (Works), ALC888S (Works), Wireless RT73 (Works), LAN (Works) - How to Install - Blog - Hardware Combos - FAQ by TJ2K7
Macbook Pro 13"
Follow meh: @icchansan

If you just want to support hackint0sh.org with a donation click here

ACHI is enabled, I had it enabled from using grub & the retail disk

I'm also using BIOS A04. Just noticed that.

Only difference with my D630 and the one in the wiki, is I have the nVidia Quatro 132M

I have a D630 and a Vostro 1700. Happens on both... SATA set to AHCI, flash module disabled, tried -s boot switch too,

Check dell vostro here

__________________
HP Pavilion Elite m9250f
iAtkos v5i (10.5.8), Asus IPIBL-LB MOD BIOS, Intel Quad Core Q6600, 4GB RAM (800mhz), 2x500GB, nVidia 8600GT (Works), ALC888S (Works), Wireless RT73 (Works), LAN (Works) - How to Install - Blog - Hardware Combos - FAQ by TJ2K7
Macbook Pro 13"
Follow meh: @icchansan

If you just want to support hackint0sh.org with a donation click here

Could it be that my BIOS is version A04?