 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
|||||||||
|
|||||||||
|
|
||||||||
|
|||||||||
11-08-2008, 05:29 PM
|
|||
|
|||
iDeneb installed.. Darwin just reboots
I got everything installed successfully. When the Darwin bootloader comes up it allows me to press f8 and input options, but if I don't and let it run, it just reboots the computer.
I'm open to options. Asus board AMD Processor 3gb DDR2 Also, I installed iDeneb on my nforce board. Used the AMD patch and did not change kernels.. EDIT: I ended up having to use Leo4AllV3 Last edited by diem; 11-09-2008 at 04:05 AM.         |
|
11-09-2008, 04:03 AM
|
|||
|
|||
|
It was actually the NVidia drivers causing it and many other issues. I finally got Leopard installed and I am online right now posting from it
 Got my linksys WUSB600N wireless adapter working as well and sound.Now my onboard Nvidia 6150LE basically has no support and I can only run it was 1024x768 on a 21" widescreen. Going to invest in a replacement on eBay. Any suggestions as far as what will EASILY work? Don't want to spend over $50 on a used Video Card. |
| Sponsored links Remove advertisements | |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Having problems booting iDeneb 10.5.5 | -a. | Installation | 7 | 03-24-2009 12:35 PM |
| Installed Leopard iDeneb 10.5.5 but unable to boot | mmmbopzombie | Installation | 20 | 01-19-2009 04:12 PM |
| iDeneb v1.3 10.5.5 problem | Undertaker1986 | Installation | 4 | 11-03-2008 08:04 PM |
| Maximum number of packages installed? | Strength | General | 1 | 04-15-2008 08:47 PM |
| Darwin Bootloader | toyanucci | Archiv (Leopard) | 4 | 03-20-2008 04:46 PM |
|
|
Linear Mode
