I have used many different methods to try an virginize my bricked iphone, but have had NO luck with any.

With the latest try, I got version 1.0.2 onto the iPhone, it does not show the EMIE number, and the WiFi does not work, but I do have the springboard up on powerup, although the phone does not work.

When I go to the last steps of trying to virginize the iPhone, I open TERMINAL and type in the CHMODE +x *.* command, and it goes through fine. The next step is to open CTIL ??, and then close out some commands, such as apple.command.***
When I go to open the application, it begins to open for a second, then closes, and goes back to the spring board. I can not get it to open, unless I reboot the iPhone, which then loses the command I put in via Terminal. Also the backspace button does not work, it goes forward.

I am using AT&T, and therefore no longer need this phone unlocked, if i could just get thisa even locked and working, i would be fine.

Last resort is to send it to someone to fix, or sell this. I have been working on this for ONE month straight, any help would be sincerely apprecaited

stupid question, but is BSD subsystem installed? I assume yes, but this sounds similar to others who have not installed this before trying to run terminal

Yes, BSD subsystem is installed, and Terminal does work, also ULctl works by itself, but not after a command is entered into Terminal

İf you lost your wi-fi , get in DFU mode, try to flash the firmware to 1.1.2.When finishes go on and control with "prefs://1f method and see if the wi-fi comes back. I have done this before on two phones.İf you back your wi-fi you can virginize with the automatic scripts.
But have a bad news about in the forum there are some threads about no wi-fi issue.Some of them have not found a solution yet.I am surprised if we have an software unlock for 1.1.3, maybe flashing to 1.1.3 could give the wi-fi back.

GOOD LUCK