|
|||||||||
|
|||||||||
|
|||
|
So yea my mom recently got her iphone 3G
and long story short she drop it like 10-15 inches off the ground with case on Now It sometimes does not get signal Most of the time get FULL BARS , but can't call out whatsoever I tested 3.0 , 3.0.1 , 3.1.2 custom ... all failed I notice if i drop it again, it works but would randomly stop working.. still full bars but no calls out or in whatsoever or sometimes no bars lol I am using T-Mobile via UltraSn0w unlock .. Please Help The phone itself it still under warranty, but if i get it swap out.. it most likely be a 3.1 which it not unlock-able yet.. and if i get it "diagnosed" then warranty would be gone.. I got several mix opinions .. some say motherboard others say just the antenna is mess up ... some even say the sim reader ( but wouldn't that give me a sim card error?) Since i can drop it 5 inch of the ground to get it working again, but slight movement of the phone like putting it on a table or something - would cause call out/in to stop working .. what could it be? .. or could it just be a lose connector?.. Any Help would be greatly appreciated ! Thanks! |
![]() |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [GUIDE] ZiPhone - unlock solution (read the warning 1st post) | geircito | Older Software Unlock Solution | 187 | 06-17-2008 09:33 PM |
| [1.1.2 OTB] > 1.1.3 HW Unlock, up and running: GSM.VN ; Geohot; Imth; and hackin0sh | Number_41 | Older Software Unlock Solution | 132 | 01-18-2008 12:18 PM |
| [GUIDE] Virginize 1.0.2 > Restore 1.1.1. > Jailbreak & Activate > Unlock 1.1.1. no PC | rjshearman | Older Software Unlock Solution | 151 | 11-12-2007 04:14 PM |
|
|