Hello To all
I have an iphone that have died after i connected it to an ipod car charger.
I have read all the forum and the most common problem is because it fries the logic board so i have order a new logic board and had it replaced yesterday,
Ok now the phone starts but after the apple logo it shows me the icon to connect to itunes like i was in restore mode but when i try to connect to the pc its not recognized by the pc, i have tried a diferent usb cable but no sucess.
After i start the iphone it only stays connected for a few seconds and then it turn off alone. i have also replaced the battery so i thougt it could be because the battery was empty so i left it for a while in the wall charger but its not charging.
I don't know what else to do, the only thing i noticed and that i am not sure is if the white cable of the baterie is well solded. could it be that? i don't thing so but i'm running out of options.

Thank You in advance

most of the time when you fry the logic board with incompatible accessories, you friedthe flat cable that conects from the bottom connector to the logic board.

i got one like that.

just change the flat cable and you will be ok.



cheers,

cRACKn

Hello cRACKn, Thank you for your help,
Anyway the phone only stays connected for a few seconds like it was in restore mode an then it turns off again, so probably it's not just the flat cable.

replace IC idoz near CPU

what is the ic and where is it exactly located?
can you get me a picture of it? Thank you

Just a quick question here, can I use the usb charge/sync cable of an ipod video to charge iphone? I just want to make sure that the use of the ipod cable didn't kill my iphone.
Thanks.