Ideneb v 1.4 and Windows 7
I have been trying for 4 days now to dual boot my Acer Aspire 5516!!! Someone please help me out here.
These are the steps I have gone through:
I have a 160 gb hard drive that i shrunk(partitioned) then formatted.
Changed my bios AHCI and vise versa
So 80 gbs for windows and 80 unallocated.
I have then tried running ideneb 8 different ways with the hard drive raw, unallocated, partitioned in FAT32, exFAT, NTFS.
I have made this partition active, inactive you name it.
Can someone please tell me how to get this hard drive to show up so i can actually install ideneb 1.4. Please elaborate i am new at this and it is driving me nuts.
Below are my specs:
Processor - Athlon 64 1.6 GHz
Installed Memory - 2 GB (DDR2 SDRAM)
Hard Drive 160 GB
Display 15.6 in. WXGA
Operating System Windows 7
THANKS IN ADVANCE! PLEASE GUYS HELP ASAP S.O.S!:fail:fail:pie:
Ideneb and Windows7 NIGHTMARE
The whole problem is I cannot see my targeted partition in disk utility.
Again these are the steps I have taken,
I Partitioned my 160 gb to 80 gbs for windows7 and 80 gb unallocated/raw.
I then TRY to install ideneb and when I get to the Disk utility and installer there is no visible hard drive. THERE ARE HARD DRIVES THAT APPEAR.
HOW TO I GET IDENEB TO SEE MY HARD DRIVE