Printable View
Dear all
I am new to iDeneb Mac .. I have installed iDeneb Mac 1.3 10.5.5 . installation completed without any problem, after that I have restarted my pc ... now it says that --no boot media found..:( and unable to boot OS ..but if I insert iDeneb DVD it starts very well and OS runs without any problem ... what it could be ??? I want my pc to start without inserting DVD each time I start my PC....
Are you dual booting ?Quote:
Originally Posted by jatin
If not, and you've got just Mac installed then load mac and then in terminal write...
sudo -s (enter your password)
fdisk -e /dev/rdisk0 (the disk number)
print (list all partitions)
flag 1 (sets partition 1 as bootable - the partiton which mac is installed on, assuming its on the first one)
quit
Mac should load on its own now, dont forget only use this if Leopard is the only OS installed on this computer.
All this does is set Mac OS X partition to active - the partition which boots basically
I have the same issue with iDeneb and IATKOS. Even when I flag it.. it refuses to boot with out the dvd and ONLY in safe mode.
hi,Quote:
Originally Posted by TJ2K7
how should i dualboot if Mac OS X is not the only os on my disk?
s: i have 1 disk (1 partition per os )
Cheers
Thnx man..... finaly I got it
It all depends on what OS your using..Quote:
Originally Posted by yorote
First Make sure XP/Vista is the active partition.
XP
Download the chain0 file (google it) and place it intO C:\ and then edit the boot.ini file and add the line
ORQuote:
C:\chain0="Mac OS x86"
Vista
Download EasyBCD and then add then Generic osx86 Entry.
:)
Quote:
Originally Posted by TJ2K7
There is single OS (iDeneb V1.3 10.5.5 Leopard) installed on 60GB harddisk drive .... No dual boot at all
What can be done now... is there any solution for this problem
Thnx
Regards
www.khatrijatin.co.nr
You said ' thx man i got it'Quote:
Originally Posted by jatin
If you've got only one OS and no dual booting then do what i said in my first post. If that doesn't work then i dont know sorry