Hello everybody!

I downloaded "Tubgirl OSX 10.4.10 AMD Test 1" and tried to install it yesterday. I need to say that it was the best installer for my computer (AMD with NForce 4 Chipset and SATA HD). The load process was very fast comparated with others. But I didn't install it yet because some errors occurs during install process.

First an error occur after the installer load. When the Language Chooser windows appeared an error occured saying that the installation process couldn't continue because an error and tell me to view error log. I saw it and I didn't found any kind of error which appear to be important. So I reboot my PC and entered at BIOS Setup of motherboard and disable SYSTEM BIOS CACHEABLE and ENABLE KEYBOARD AND MOUSE USB SUPPORT. After it I reload the installer perfectly. But when it's verifying the DVD installation media it show me a message saying that an error was detected but I can choose IGNORE & CONTINUE. I pressed this buttom and at the middle of installation process an error occurred asking me to reboot the system and initiate all the process again.

Resuming, some information about what I did:

at motherboard BIOS:
SYSTEM BIOS CACHEABLE = Disabled
KEYBOARD USB SUPPORT = Enabled
MOUSE USB SUPPORT = Enabled

selectioned packages at installation process:
all that corresponded to my hardware, like ATI X1600, X11 and I disable all packages used to translate Operation System. (I'll use English support only).

I already read about some people that needed to disable ATI X1600 support during installation process and install it after the installation process. It's true?!

Anybody know if I need to disable/enable some parameters at motherboard BIOS Setup?!

My hardware configuration is the follow:
Processor: AMD Atlhon 63 3800+
Motherboard: ABIT KN8 SLi
Chipset: NForce 4
Storage: 2 x SATA (160GB and 120GB)
Graphic Card: ATI X1600
Memory: 2GB

Please, reply me people!!! =D

My best regards!