I successfully Installed Leopard on a COMPAQ Presario M2000 Notebook that I purchased recently. Now, I installed Kalyway on it and I got a b0 error on booting...
After reading some solutions, I did this:

Start with the installation disk
At darwin prompt, press F8, then input -v -s and stroke return
now wait for console (the shell #)
when the shell is ready, enter fdisk -e /dev/rdisk0
it will load fdisk, you should see:
fdisk 1>
with a prompt.
Here enter “flag 1″ (without quotes) and then return
then enter “quit” (w/o quotes) and then return
it should says “MBR saved”
now type “exit” (again, w/o quotes) and return


And now, after reboot, I get the: HFS+ Partition error.

Please Help....

I formated the whole HD and installed XP on partition 1 and Leopard on partition 2, and booted into XP and added the Chain0 Leopard into boot.ini

But after booting into Leopard, same error again: HSF+ partition error.

What version of OSX?

Originally Posted by f41qu3

What version of OSX?

Leopard 10.5.1

Retail DVD? Restore Disc? Kalyway? Leo4All?

Originally Posted by f41qu3

Retail DVD? Restore Disc? Kalyway? Leo4All?

Kalyway.
Its mentioned in the thread topic

This is hard incompatibility with your HDD chipset controller.

Try test using a USB case for HDD...if it works, or try add kexts (or modify) to recognize HDD or only using by USB connection.

Post impressions, goodluck,

I have this error too
"I got a b0 error on booting..." ill try this later! tnx man!

chim3ra

Originally Posted by jashsayani

I successfully Installed Leopard on a COMPAQ Presario M2000 Notebook that I purchased recently. Now, I installed Kalyway on it and I got a b0 error on booting...
After reading some solutions, I did this:

Start with the installation disk
At darwin prompt, press F8, then input -v -s and stroke return
now wait for console (the shell #)
when the shell is ready, enter fdisk -e /dev/rdisk0
it will load fdisk, you should see:
fdisk 1>
with a prompt.
Here enter “flag 1″ (without quotes) and then return
then enter “quit” (w/o quotes) and then return
it should says “MBR saved”
now type “exit” (again, w/o quotes) and return


And now, after reboot, I get the: HFS+ Partition error.

Please Help....

Originally Posted by chim3ra

I have this error too
"I got a b0 error on booting..." ill try this later! tnx man!

chim3ra

Yeah. Try it and report back. I installed it from another distro and now I dont get this error. Another error though!