Hi,
i write this tutorial to create a dualboot using only Chameleon 2 RC2 between Seven and Leopard to share with you:

- Install Leopard, there are a lot of guides to know how install it
- Install Seven with its DVD
- After Seven is installed, at your reboot, Seven will be the only OS bootable
- In Seven do this steps:
- Open "Run" and type "cmd"
- type "diskpart"
- type "list disk"
- type "select disk X", where X is the HDD number where Seven and Leopard are installed
- type "list partition"
- type "select partition X", where X is the n° of Leopard partition
- type "active"
- type "exit"
- reboot Seven

- Now reinstall Chameleon bootloader
- Insert Seven's DVD and go to Prompt in the "repair my computer" section
- Now, once Prompt appears, type this command:
- type "cmd"
- type "diskpart"
- type "list disk"
- type "select disk X", where X is the HDD number where Seven and Leopard are installed
- type "list partition"
- type "select partition X", where X is the n° of Seven partition
- type "active"
- type "exit"
- reboot

- With the Seven's DVD into, goes into
- "repair my computer"
- select "repair and restart" which appears automatically

- Now Seven will load, and when you are into Seven do this steps:
- Open "Run" and type "cmd"
- type "diskpart"
- type "list disk"
- type "select disk X", where X is the HDD number where Seven and Leopard are installed
- type "list partition"
- type "select partition X", where X is the n° of Leopard partition
- type "active"
- type "exit"
- reboot once again

and...

NOW CHAMELON SHOULD BOOT SEVEN AND LEOPARD AS WELL